[MAGEEC] Installing pyusb as per wiki instructions
Jeremy Bennett
jeremy.bennett at embecosm.com
Fri Feb 21 11:05:46 GMT 2014
On 20/02/14 20:45, Alex J Lennon wrote:
> Hi all,
>
> I'm working through a clean install of the power monitoring software as
> per the Software Requirements section of the workshop Wiki page here:
>
> http://mageec.org/wiki/Workshop#Software_setup
>
> I ran into some trouble with my standard Ubuntu LTS VM and so tried with
> the latest Ubuntu 13.10 but it gives the same error:
>
> ~$ sudo pip install pyusb docopt
> Downloading/unpacking pyusb
> Could not find a version that satisfies the requirement pyusb (from
> versions: 1.0.0a2, 1.0.0a2, 1.0.0a3, 1.0.0a3, 1.0.0b1)
> Cleaning up...
>
> I found what I think is the solution with the following which seems to
> get it installed:
>
> ~$ sudo pip install --pre pyusb docopt
> Downloading/unpacking pyusb
> Downloading pyusb-1.0.0b1.tar.gz (44kB): 44kB downloaded
> Running setup.py egg_info for package pyusb
>
> Downloading/unpacking docopt
> Downloading docopt-0.6.1.tar.gz
> Running setup.py egg_info for package docopt
Hi Alex,
Thanks for this. Would you add a note about this on the Wiki, so anyone
else who hits the same problem can try your approach.
Best wishes,
Jeremy
> Best Regards,
>
> Alex
>
>
> _______________________________________________
> mageec mailing list
> mageec at mageec.org
> http://mageec.org/cgi-bin/mailman/listinfo/mageec
>
--
Tel: +44 (1590) 610184
Cell: +44 (7970) 676050
SkypeID: jeremybennett
Twitter: @jeremypbennett
Email: jeremy.bennett at embecosm.com
Web: www.embecosm.com
More information about the mageec
mailing list